| Description | . . . . . . . . . . . . . . . . . . . . . . . . . . 4-1 CHAPTER 5. TEST FUNCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-1 CHAPTER 6. DOWN LOAD FUNCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-1 CHAPTER 7. SERVICE PRECAUTION . . . . . . . . . . . . .... |
| Features |
PRECAUTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-1
ww.DataSheet4U.com
CHAPTER 8. CIRCUIT DIAGRAM & PWB LAYOUT . . . . . . . . . . . . . . . . . . . 8-1
PARTS GUIDE
Parts marked with " " is important for maintaining the safety of the set. Be sure to replace these parts with specified ones for maintaining the safety and performance of the set.
SHARP CORPORATION
www.DataSheet4U.com
This document has been published to be used for after sales service only. The contents are subject to change without notice.
DataSheet 4 U .com
www.DataSheet4U www.DataSheet4U.com 4U.com
...
|
| Datasheet |
 ER-A440 Datasheet - 1.28MB |
| Part Number | Description |
|---|---|
 Sharp |
Installation Manual , descriptions are omitted. Note for operations Procedure 1) Unplug the AC cord from the wall outlet. 2) Set the MODE switch to the (SRV′) position. 3) Plug in the AC cord to the wall outlet. 4) While holding down JOURNAL FEED key and RECEIPT FEED key, turn to (SRV) position from (SRV′) position. 5) Key position assignment: After the execution of MRS-2, only the RECEIPT FEED and JOURNAL FEED keys can remain effective on key assignment. Any key can be assigned on any key position on the main keyboard. [key setup procedure] *2 • Before operation, ground the operator’s body and perform other necessary measure against static electricity. • During operations, disconnect the AC cord from the ou... |